Название: BuildIt Oscilloscope 3. Volume 6
Автор: Joseph Berardi
Издательство: Joseph Berardi
Год: 2018
Страниц: 79
Формат: AZW3, PDF (conv)
Размер: 10 Мб
Язык: English
This project demonstrates how to attach an A/D converter chip to the Arduino Uno Rev 3 board interface and use the Arduino IDE graphical interface as an oscilloscope. To get the novice project builder started there are several experiments for learning the Arduino IDE environment that can be performed prior to building the Oscilloscope 3 project on a solderless breadboard.
Table of Contents
BuildIt Oscilloscope 3
Warning
Disclaimer
Non-liability Statement
BuildIt Books
BuildIt Book List
Author’s Paperback Books (Year Published)
Introduction
Getting Started
Electronic Primer
Introduction to a Sketch
Arduino Home Page
Arduino Software Page
Arduino USB COM Port Driver
Installing the FTDI Virtual COM port driver
Arduino Board
Sketch Tutorial
Step 1
Arduino Uno Rev 3 Board Setup
Step 2
Arduino Uno Rev 3 Port Setup
Step 3
Arduino Uno Rev 3 New File
Step 4
Step 5
Arduino Uno Rev 3 Sketch Verify
Step 6
Upload Error
Step 7
Experiments
Experiment 1 - Blinking LED
Experiment 2 - Dim LED
Experiment 3 - Dim and Blink LED
Experiment 4 - PWM Square Wave and Serial Monitor
Experiment 5 - PWM Square Wave, RC Filter and Serial Plotter
Oscilloscope 3 Project
ADC0820 Analog-to-Digital Converter
Components Required
Definitions
Datasheet Information
ADC0820 Data Sheet Information
Electronic Parts Suppliers
Trademarks
References
Нашел ошибку? Есть жалоба? Жми!
Пожаловаться администрации